Kerala PSC Previous Years Question Paper & Answer
Page:5
Below are the scanned copy of Kerala Public Service Commission (KPSC) Question Paper with answer keys of Exam Name 'TECHNICIAN GR II GENERAL MECHANIC GENERAL SOCIETY CATEGORY KCMMF LTD' And exam conducted in the year 2014. And Question paper code was '085/2014'. Medium of question paper was in Malayalam or English . Booklet Alphacode was 'A'. Answer keys are given at the bottom, but we suggest you to try answering the questions yourself and compare the key along wih to check your performance. Because we would like you to do and practice by yourself.
85. ——————are used for remove clinkers from the fire. +
(4) 51०९] (B) Tongs
(८) Hammer (D) None of these
38, Clapper hox in shaper used for ;
(ಗ) To avoid length of tocl (7) To lift the tool during cutting stroke
)0 To ensure cutting action (D) To lift the tool during return stroke
37, While normalizing the components should be cooled :
(ಗೆ) by dipping in water (B) by forced air
(C) by quenching in oil (D) In still air to room temperature
38. What is the purpose of steady rest using in lathe?
(ക Additional clamp support for the head stoke
(B) Additional support for the work
(C) Additional support for the tool
(D) To reduce job speed
39. The drilled hole is larger than the size of drills used. The reason is :
( Too much speed യ Helix angle not accurate
(C) Lip clearance not accurate (D) Unequal length of the cutting edge
40. The purpose of using sign bar is to :
(ಗ) Measure the length of the job (B) Find the angle of taper job
(0) Check the flatness of job (D) Check the level of the job
41. Honing is used to finish :
(ಗಿ) Flat surface (B) Shaft
(C) Hole (D) Irregular surface
42, Gasolineisa:
(4) Fuel (B) Lubricator
(C) Cutting fluid (D) None of these
43. Which is the oldest machine?
(^) Lathe (7) Triller
)© Miller യ 81010೯
A 7 85/2014
௩.01
