Kerala PSC Previous Years Question Paper & Answer
Page:11
Below are the scanned copy of Kerala Public Service Commission (KPSC) Question Paper with answer keys of Exam Name 'TECHNICIAN GR II GENERAL MECHANIC GENERAL SOCIETY CATEGORY KCMMF LTD' And exam conducted in the year 2014. And Question paper code was '085/2014'. Medium of question paper was in Malayalam or English . Booklet Alphacode was 'A'. Answer keys are given at the bottom, but we suggest you to try answering the questions yourself and compare the key along wih to check your performance. Because we would like you to do and practice by yourself.
85. What is the ratio between two sides of the drawing sheet?
ல 12 B 3:48
(ഒ: 1: ™ 1:43
86. fIgnition system are not required for ———————— engine.
ல ணே (B) Diesel
(©) Petrol (D) None of these
87. Identify the characteristics of flexible hack-saw blade :
(A) Full width hardened (B) Except pin hole hardened
(ര Only teeth are hardened (D) Nao portion hardened
88. Copper is used for soldering iron because :
(4) Its melting point is high (B) [ഭജ high resistant to wear
(0 It ean prevent corrosion (D) It is good conductor of heat
89. A two stroke eyele engine produces one power stroke in -
(ಯ) Each revolution of crankshaft (3) Two revolution of crankshaft
(C) Three revolution of erankshaft (D) TFour revolution of crankshaft
90, முட... [5 8 safety device used for protecting eyes while working in the furnace.
(ക) Goggles (B) Mask
(C) Apron യ வளை
91. An opening through which the blast air enters blast furnace 18 ;
(A) Wind box (18) Blower
(€) Tuyers (D) Slag hole
92, — s used to hold and grip the pipe.
(ക Pipe vice (B) Die stock
(C) Pipe wrench (D) Pipe grip
A 13 85/2014
மாப]
