Kerala PSC Previous Years Question Paper & Answer
Page:2
Below are the scanned copy of Kerala Public Service Commission (KPSC) Question Paper with answer keys of Exam Name 'TRADE INSTRUCTOR GR II TOOL AND DIE MAKING TECHNICAL EDUCATION' And exam conducted in the year 2015. And Question paper code was '043/2015'. Medium of question paper was in Malayalam or English . Booklet Alphacode was 'A'. Answer keys are given at the bottom, but we suggest you to try answering the questions yourself and compare the key along wih to check your performance. Because we would like you to do and practice by yourself.
9,
೩0.
11.
12.
13.
14.
15.
The heat treatment for improving machinability is :
(ಗಿ) Spherodising (B) Tempering
(C) Normalizing ↴ (D) Hardening
Which one of the following is a three dimensional figure? :
(ക Trapezium (18) Rhombus
(€) Cycloid (2) Cone
If the radii of two spheres are in the ratio 1:2 their volume will be in the ratio :
@ 2 B) 4
(¢) 8 (D) 1:16
The length of diagonal of a square is 10cm. then its area is :
( 10054. دہ (B) 1086. 0೫
) 50sq.cm (D) None of the above
Which of the following is a unit for measurement of angle?
(ಯ) Degree (B) Minute
(൫ இலம் (M) All the above
The value of cos60 is :
(A 05 ಊ% 1
© o ® 2
High speed steel is used to make :
(ಡಿ) engine parts of an automobile (8) aircrafl engine
(C) ೫0661 01 81100170011 (D) cutting tool
In normalizing cooling is done in :
வி Water 1 വി
(0) Furnace (D) Air
43/2015 4
