Kerala PSC Previous Years Question Paper & Answer
Page:7
Below are the scanned copy of Kerala Public Service Commission (KPSC) Question Paper with answer keys of Exam Name 'LABORATORY TECHNICAL ASSISTANT MECHANIICAL SERVICING / AGRO MACHINERY VHSE' And exam conducted in the year 2015. And Question paper code was '027/2015'. Medium of question paper was in Malayalam or English . Booklet Alphacode was 'A'. Answer keys are given at the bottom, but we suggest you to try answering the questions yourself and compare the key along wih to check your performance. Because we would like you to do and practice by yourself.
2
81.
53.
87,
The manufacturer of fuel injection pump :
കര 100 (B) HMT
(C) HAL () BHEL
When the vehicle is climbing up the hill track the gear box suplies?
(ക Low torque (B) Not torque
(C) Higher torque (D) Any of them
For cutting external thread on bars which tool is used :
(ക) Taps (B) Reamer
(C) Dies (D) Drills
A propeller shaft connects :
(ಹ) Engine with clutch (8) Clutch with gear box
(0 Gear box with differential (D) Gear box with universal joint
In an micro meter pitch of the thread is 1 mm and there is 100 division on the thimble scale,
The least count is : ⋅
↭⋯⋯ ஐ 1/100 MM
(©) 41 © 4
1777100 079 18 701 a holding tool?
( Bench vice (B) Ball peen hammer
(C) Pipe vice (D) Ceclamp
Maintenance cost of magneto ignition system compared to that of battery- coil ignition
system is :
(ക) Higher (8) Same
(C) Less (D) Not predictable
ploughs are used in the area where climate is dry and where the soil is rough
and stony. १
(മ Disk plough (8) Mould board plough
(C) Sweeps (D) Sub soiler
Heat exchange hetween water and nir in a radiator take place by :
(മ Conduction (B) Convention
(© (இ ஊம்) (D) Radiation
9 27/2015
[P.T.0]
