Kerala PSC Previous Years Question Paper & Answer
Page:8
Below are the scanned copy of Kerala Public Service Commission (KPSC) Question Paper with answer keys of Exam Name 'LECTURER IN AUTOMOBILE ENGINEERING POLYTECHNICS TECHNICAL EDUCATION' And exam conducted in the year 2016. And Question paper code was '061/2016'. Medium of question paper was in Malayalam or English . Booklet Alphacode was 'A'. Answer keys are given at the bottom, but we suggest you to try answering the questions yourself and compare the key along wih to check your performance. Because we would like you to do and practice by yourself.
60.
61.
62.
64.
65.
67.
Braking is produced by the frictional effect between the brake drum and the :
(A) Wheel Studs (18) Wheel rim
(0 Brake shoes (D) Wheel cylinder pistons
An under inflated tyre will wear the tread most :
(ಗಿ) Near the centre (3) In the cross section direction
(C) In the lateral direction (D) Near the edges
Which of the following can be adjusted by modifying the tie road attachment length?
{A) Caster angle (B) Toein and out
(0) Camber angle (D) Steering gear ratio
Ignition in a SI engine takes place when the piston is :
(ಯ) Exactly at TDC position on its compression stroke
(3) Leaving the TDC position on its compression stroke
(0) Approaching TDC position on its exhaust stroke
(D) Approaching TDC position on its Compression stroke
Critical whirling speed of a propeller shaft is increased by :
(ಹಿ) Increasing its length (2) Decreasing its diameter
(0) Decreasing its length (D) None of the above
The torque available at the contact between driving wheels and road is known as :
(ക Brake effort (8) Tractive effort
(0 Clutch effort (D) None of the above
The tool employed to measure the shaft run out is the :
(ಯ) Feeler gauge (B) Micrometer
(2) Dial gauge (D) Caliper
Trafficators are light signal used for :
(A) Indicating the direction in which turning
(B) Light traffic
(C) Reversing the car in traffic
(D) Heavy Traffic
061/2016 10
