D:-Uneven application of pressure on the wheel
Correct Answer:- Option-C
Question90:-Which statement is true with the absolute mode?

A:-The coordinates of a point are always referred with reference to the same
datum

B:-The coordinates of any point are calculated with reference to the previous
point

C:-The coordinates of a point are always different from the previous point
D:-None of these
Correct Answer:- Option-A
Question91:-Which one of the statement is true with the tooling system in CNC?
A:-The letter 'H' indicates geometry offset
B:-The letter 'H' indicates work offset
C:-The letter 'H' indicates wear offset
D:-The letter 'H' indicates tool length offset
Correct Answer:- Option-D

Question92:-The phenomenon happens when small particles of the material being
ground become embedded in the space between the grains of the grinding wheel is

A:-Dressing
B:-Grooving
C:-Loading
D:-Truing
Correct Answer:- Option-C
Question93:-The process of work offset in CNC lathe is
A:-Setting the job at correct coordinates

B:-Setting the job and set the tool to touch the face of the job and the
diameter of the job

C:-Setting of the tool at the correct reference point
D:-Setting the job at correct axis according to the length of the tool
Correct Answer:- Option-B
Question94:-Which one of the statement is true with the M code in CNC?
A:-M 04 S 500 indicates spindle rotation CW 500 rpm
B:-M 04 S 500 indicates spindle rotation CCW 500 rpm
C:-M 04 S 500 indicates cutting feed rate of 500 mm/rev
D:-M 04 S 500 indicates cutting speed of 500 m/min
Correct Answer:- Option-B

Question95:-Which of the following statement is true with the selection of an