Kerala PSC Previous Years Question Paper & Answer

Title : LABORATORY TECHNICAL ASSISTANT MAINTENANCE AND REPAIRS OF TWO WHEELERS AND THREE WHEELERS VHSE
Question Code : A

Page:4


Below are the scanned copy of Kerala Public Service Commission (KPSC) Question Paper with answer keys of Exam Name 'LABORATORY TECHNICAL ASSISTANT MAINTENANCE AND REPAIRS OF TWO WHEELERS AND THREE WHEELERS VHSE' And exam conducted in the year 2015. And Question paper code was '230/2015'. Medium of question paper was in Malayalam or English . Booklet Alphacode was 'A'. Answer keys are given at the bottom, but we suggest you to try answering the questions yourself and compare the key along wih to check your performance. Because we would like you to do and practice by yourself.

page: 4 out of 12
Excerpt of Question Code: 230/2015

24.

25.

26,

27,

28.

29.

30.

31.

82.

What will be the open circuit voltage of a cell of a fully charged battery of lead acid type?

(ಯ) 126V ത 381V
(0 21V യ) 10४
In an electric circuit the ammeter is connected in :
(A) parallel to the circuit (B) series to the circuit
(0) either series or parallel (D) none of the above

In compound wound starting motors the field വേ is :
(है) Connected parallel with the armature
(B) Both series and parallel with the armature .
(0) Connected in series with the armature
(D) None of the above '

The spark plug gap is in the range of :
(4) 2-3mm (B) 06tolem
(€) 0.50 1.5 घा ) 0 0

The centrifugal force on the pressure plate of semi centrifugal clutch can be adjusted by :
(ക adjusting screw on lever (B) adjusting nut on the pressure plate
(€) adjusting spring force (D) pivoted ring

The type of gear wheels used in sliding mesh gear box is :

(4) helical gear (B) double helical gear

(C) epur gear (D) spiral gear
The tool which is used to remove gear, bearing, wheels and pulleys from their attaching
components are :

(ಗ) Screw driver 18 Monkey plier

(0 Pullers (D) Hammer

In Semi floating type rear axle, the bearing is located :
ക്ര On the axle and inside axle casing (B) On the axle casing and inside the hub
(C) On the axle and inside the hub (D) None of the above

Which of the following is a finishing operation of machined components?
(ക) Broaching © Cyaniding
( Vulkanisation (D) Honing

230/2015 6 i

Similar Question Papers

Ask Question

(Press Ctrl+g to toggle between English and the chosen language)


Questions & Answers

LABORATORY TECHNICAL ASSISTANT MAINTENANCE AND REPAIRS OF TWO WHEELERS AND THREE WHEELERS VHSE : Video