C:-Brackets
D:-Belts
Correct Answer:- Option-B
Question29:-Excess fuel pressure in a CRDI engine system is protected with a
ಹರಟ
B:-Rail pressure sensor
C:-Pressure limiter valve
D:-Flow limiter
Correct Answer:- Option-C
Question30:-The function of an air cleaner
A:-Act as silencer
B:-Act as flame amrester
C:-Filtering intake air
D:-All of these
Correct Answer:- Option-D
Question31:-What are the basic factors affect the gear selection?
A:-Vehicle load and engine speed
B:-Vehicle speed and engine load
C:-Vehicle load and road condition
D:-Engine speed and road condition
Correct Answer:- Option-B
Question32:-The cavitations formed inside the torque converter centre is the result of
A:-Low oil pressure
B:-Less engine RPM
C:-Less torque conversion
D:-None of these
Correct Answer:- Option-A
Question33:-The plunging type constant velocity joint is employed at the end of the drive shaft.
A:-Wheel end
B:-Differential end
C:-Both (3) 8೧6 (2)
D:-Main shaft end
Correct Answer:- Option-B
Question34:-Which of the following is not a reason for humming noise णि) the rear axle?
A:-Wom out differential bearings
B:-Backlash between crown and pinion
C:-Wom out gears
D:-Wom out axle shaft splines
Correct Answer:- Option-D
Question35:-The material used to improve the resistance to wear of rubber threads in a tire is
A:-Nylon
B:-Rayon
C:-Carbon black
D:-Terylene
Correct Answer:- Option-C
Question36:-Which part of a master cylinder serves to retain the residual pressure in the brake lines even when the brakes
are released?
A:-Check valve
B:-Piston

D:-Primary cup
Correct Answer:- Option-A
Question37:-Lamda sensors are located at
A:-Exhaust manifold
B:-Inlet manifold
C:-Throttle body
D:-Timing cover
Correct Answer:- Option-A
Question38:-Sedimentation type fuel filters are generally used as