Correct Answer:- Option-C

Question4:-Which of the statement is/are true with the marking tools?

|. A universal surface gauge is used to scribe lines parallel to a datum surface
ii. A universal surface gauge is used to set the job on machines parallel to a
datum surface

iii. Angle of centre punch is 90°

A:-All of the above (i, ii and iii)
B:-Only (ii and iii)

C:-Only (i and ii)

D:-Only (i and iii)

Correct Answer:- Option-A

Question5:-Which of the following statement is/are not true with the work holding
device - vices?

1. In abench vice, to hold a finished work, soft jaws made of brass over the
regular jaws

ii. In a pipe vice, the screw is horizontal and movable so the jaw works vertically
iii. The length of hand vice varies from 125 mm to 150 mm

A:-Only (i and iii)

B:-All of the above (i, ii and iii)
C:-Only (ii and iii)

D:-Only (i and ii)

Correct Answer:- Option-D

Question6:-Which of the statement is/are true with the type of screw drivers?

1. Screw drivers are specified according to the length of blade and thickness of tip
ii. Screw drivers are specified according to the length of blade and width of tip

iii. The normal width of blade varies from 5 mm to 8 mm

A:-Only (ii and iii)

B:-Only (ii)

C:-Only (i and iii)

D:-Only (i and ii)

Correct Answer:- Option-B

Question7:-Which of the following statement is/are not true with the spanners?

i. In British system the nominal size of bolt or nut is used to identify the spanner
ii. The adjustable spanner has its jaws set at an angle of 45° to the handle

iii. Normally spanners have a length that is about ten times the width of the jaw
opening

A:-Only (ii)

B:-Only (ii and iii)

C:-Only (i and iii)

D:-All of the above (i, ii and iii)
Correct Answer:- Option-A