Correct Answer: Option-C
Question24:-There is either a positive clearance or negative clearance in
AcTransition fit
B:-Clearance fit
Cointerference fit
D-None of the above

Correct Answer: Option:

‘Question25:-In hole basis system and for a clearance fit, the basic size of shaft is 30 mm, minimum clearance is 0.02 mm, tolerance on hole is 0.033 mm, tolerance on shaft is 0.021
mm, The maximum limit of hole equals,

30ھ
‎B:-30.033 mm‏
‎mm‏ 29.98:€
‎D-None of the above‏
‎Correct Answer:- Option ®‏
‎Question26:-In hole basis system‏
‎കണട minimum limit of hole is equal to the basic size of the hole‏
‎Bs-The maximum limit of shaft is equal to the basic size of the shaft‏
‎C=The minimum limit of shaft is equal to the basic size of the shaft‏
‎D-None of the above‏
‎Correct Answer:- Option-é‏
‎ப shaft basis system the maximum limit of shafts‏
‎‘AcLess than the basic size of the shaft‏
‎B:-Greater than the basic size of the shaft‏
‎C:Equal to the basic size of the shaft‏
‎D-None of the above‏
‎Correct Answer:- Option-C‏
‎Question28:-The extent to which the measured value deviates from the true value is called‏
‎AcError‏
‎Bs-Accuracy‏
‎C-Range‏
‎D-None of the above‏
‎Correct Answer:- Option ®‏
‎Question29:-The ratio of output to input for a given measuring system refers‏
‎Actfficiency‏
‎B:-Linearity‏
‎ടലി‏
‎D-Sensitivity‏
‎Correct Answer:- Option-D‏
‎Question30:-The advantage of vernier caliper over micrometer is that‏
‎‘Acs easier and quicker to use‏
‎more accurate‏ 8:15
‎C-Can be used to make both inside and outside measurements over a range of sizes‏
‎D-All of the above‏
‎Correct Answer:- Option-C‏
‎Question31:-The valve permits movement of fluid in one direction only is called‏
‎AcGate valve‏
‎B:-Globe valve‏
‎CCheck valve‏
‎D-None of the above‏

Correct Answer: Option-C