A:-Synchronizing unit stuck
B:-Synchronizer worn-out
C:-Bearing worn out or dry
D:-Defective gear shift mechanism
Correct Answer:- Option-C
Question10:-What is the load taken by a taper roller bearing?
A-Radial Load
-Axial and Radial Load
C:-Thrust Load
D:-Non thrust Load
Correct Answer:- Option-B
Question11:-The efficiency of hydraulic braking system is
A:-40-50%
B:-50-60%
C:-60-70%
D:-About 90%
Correct Answer:- Option-D
Question12:-If proportioning valve is not working
A:-Front brakes may lock
B:-Rear brakes may lock
C:-Front brakes may drag
D:-Rear brakes may drag
Correct Answer:- Option-A
Question13:-What is the main cause for wear on one side of tyre?
A:-Over inflation
B:-Under inflation
C:-Improper camber
D:-Improper caster
Correct Answer:- Option-C
Question14:-Disc brakes self-adjust when the lining wear allows the piston to
A:-Contact the disc
B:-Slide outward through the seal
C:-Cause seal deflection
D:-Reposition the seal groove in the caliper
Correct Answer:- Option-B
Question15:-What causes "Air suction" in pump of hydraulic power steering system?
A:-Noise
B:-Low pressure
C:-High fluid level
D:-Steering wheel play
Correct Answer:- Option-A

Question16:-What is the compression ratio of an engine, its clearance volume is 10 c.c. and
swept volume is 90 6.௦?

0:-11 : 1

Correct Answer:- Option-C

Question17:-In a six cylinder engine, the power impulse occurs after 'x' degrees of crank shaft
rotation. Where 'x' is

A:-360

8:-240

C:-120

D:-90

Correct Answer:- Option-C

Question18:-In a Diesel fuel injection pump, the effective pressure strokes of the plungers
are regulated by means of a

A:-Fuel pump
B:-Control rack
C:-Needle valve