Correct Answer:- Option-D
Question29:-The function of fly wheel is
A:-Smoothen the power flow
B:-Serve as the part of the clutch
C:-For starting purpose
D:-All of the above
Correct Answer:- Option-D
Question30:-Excessive end play of the crank shaft is prevented by using
A:-Sleeve bearing
B:-Thrust bearing
C:-Shaft journal
D:-Fly wheel
Correct Answer:- Option-B
Question31:-The throttle position sensor can be checked by
A:-A digital voltmeter
B:-An ohmmeter
C:-Ammeter
D:-All of the above
Correct Answer:- Option-B
Question32:-In petrol fuel injection system, the two positions of injectors are
A:-In the cylinder and on the intake port
B:-On the two sides on the air horn
C:-The throttle body and in the intake port
D:-Intake and exhaust ports
Correct Answer:- Option-C
Question33:-Which type of tool is used to tighten bolt and nut with specified torque ?
A:-Double end spanner
B:-Socket wrench
C:-Torque wrench
D:-Ring spanner
Correct Answer:- Option-C
Question34:-Two type of fuel supply system used in SI engine are
A:-Carbureted and diesel
B:-Fuel injection and diesel
:-Port and throttle body
D:-Fuel injection and carburattor
Correct Answer:- Option-D
Question35:-In the clutch disc, the torsional vibrations is absorbed by the
A:-Splines
B:-Friction pad
:-Coil springs
D:-Cushion springs
Correct Answer:- Option-C
Question36:-The distance difference between the vehicle wheel bases from one side to the other is known as
A:-Thrust radius
B:-Wheel track
C:-Scrub radius
D:-Set back
Correct Answer:- Option-D
Question37:-In throttle body injection system install the injector using new "O" rings lubricated or coated with
A:-Petrol
-Rubber sealent
C:-Gasket sealer
D:-Clean engine oil
Correct Answer:- Option-D
Question38:-The basic control device of the carborattor is
A:-Needle valve
B:-Chock valve
C:-Throttle valve